Product Categories
Social Media
Home > News > Content
Maintenance And Maintenance Of Small Peanut Shelling Machine
- Jun 08, 2017 -

Small peanut shelling machine is through the high-speed rotation of the body, the peanut shell removed, and keep the peanut complete small small peanut shelling machine.

Small peanut shelling machine is through the high-speed rotation of the body, the peanut shell removed, and keep the peanut complete small small peanut shelling machine.

1, shelling clean, high productivity, the removal of the device shelling machine, Small Peanut Sheller also requires a higher degree of cleanliness.

2, the loss rate is low, broken rate is small. ③ simple structure, the use of reliable, easy to adjust, low power consumption, there is a certain degree of versatility, can take off a variety of crops to improve the utilization of the machine.

2. Requirements for peanuts (fruits). Peanut dry and wet appropriate, too dry is broken high, too wet is the impact of work efficiency.

3, winter shelling, shelling with about 10 kg before the warm water evenly sprayed on 50 kg of fruit, and covered with plastic film for about 10 hours, and then in the sun drying about 1 hour to start shelling, Small Peanut Sheller other seasons with Plastic film covers the time for about 6 hours, the rest of the same.

4, can be more dry peanuts (fruit) immersed in a large pool, soaked immediately after the plastic film and covered with 1 day or so, and then dry in the sun, to be wet and wet after the start shelling.

5, the requirements of the voltage and the choice of the workplace. Single-phase motor households and scattered, coupled with the use of wires and circuits is not very standard, resulting in substation far from the user voltage is insufficient, therefore, Small Peanut Sheller the workplace should be selected from the transformer closer to the place.

Maintenance and Maintenance of Small Small Peanut Shelling Machine

1, small small peanut shelling machine with V-belt drive. The new band in the use of a period of time, due to the role of tension will gradually elongated relaxation, should be adjusted according to the situation, all parts have tightening wire and tension wheel.

2, the sieve hanging shaft and all the activities of the bearings should be promptly checked with or without oil wear and tear, once the oil loss should be promptly refueling replacement

3, the motor temperature can not exceed 60 degrees Celsius, Small Peanut Sheller the bearing temperature should not exceed 25 degrees Celsius, found that the temperature should be too high to detect the reasons and ruled out.

4, small small peanut shelling machine in use, should always pay attention to the operation of the various parts, check the various parts of the fastening bolts are loose, if found loose should be fastened at any time. Especially the high speed parts, such as: the upper and lower fan blades, especially the lower fan blades pay attention to whether the wear or fracture, the blade external reinforcement plate is worn or deformed, such as the problem should be timely repair or replacement; sorting screen shaft, Sorting sieve connections, etc. should pay special attention to inspection.

5, the bottom of the clean-up work: rubbing the machine's sieve bottom (fish plate) hole timing with a wire brush cleaning, sieve bottom hole was blocked, kernel and peanut fruit in the proportion of sieve can not tell, the speed is slow, From the direction of small fruit into the secondary work warehouse, Small Peanut Sheller increased peanut broken rate, to stone machine and the same punching machine, need to clean the screen at the end of time.

6, after the processing season, should be small small peanut shelling machine for a major inspection. First check the roller shaft, eccentric shaft, fan shaft operation, wear; second check the bottom of the screen whether there is deformation or crack; Finally check the sorting screen wear situation. After the inspection, the damaged part should be repaired, remove the dirt and residual peanuts in the machine, tighten all the bolts, all the oil on the bearing, remove the belt, attach the storage for the next season.